Fold ‘Em to the Wall

Fold 'em to the Wall 16

I’m redecorating my office at work so it less resembles a prison cell and more resembles a place where I spend the majority of my non-traveling time. I’ll show you the big before-and-after when I’m completely done but until then I’ll keep you updated on the cheap and easy things I’ve done in order to make the room a little bit more ME.

Fold 'em to the Wall 7

Here’s the first one. For this you need some origami paper, some tape (I used double-sided tape), some foam board (or poster board), a bone folder (optional), a pencil, and a ruler. I used some large scale origami with plain colours, but this would easily work on a smaller scale with the tiny pieces of patterned paper on a smaller board.

Fold 'em to the Wall 2

I started by matching up two sides of the sheet of origami and gently pinching the outside edge of the fold, just so I could see where the centre was.

Fold 'em to the Wall 3

Then I did that in the other direction.

Fold 'em to the Wall 4

Using those markers as guidelines, I folded each corner of the paper into the centre of the page. It doesn’t have to be perfect; I think it looks a little better when it’s all irregular.

Fold 'em to the Wall 5

I did that with every colour I had, one each, for 20 squares total. You can obviously do as many as you like.

Fold 'em to the Wall 8

Then I did some figuring to sort out how I wanted them to look and where I wanted them to be.

Fold 'em to the Wall 9

I had to do some math to figure out how they were going to fit on the foam board I had.

Fold 'em to the Wall 10

In actual fact they were going to fit across two boards. So the pieces that fit across this divide between the two I was going to leave off until I’d mounted the boards on the wall. That seemed easiest.

Fold 'em to the Wall 11

I decided it looked best if I had them in touching columns with a bit of space in between. I measured carefully to make sure they were evenly spaced and made pencil marks to show me where to stick things.

Fold 'em to the Wall 12

Then it was just a matter of applying some tape. And some dog hair. But that goes without saying.

Fold 'em to the Wall 14

Here it is, on my ugly green office wall (not to be confused with my ugly white office wall and my two ugly red office walls).

Fold 'em to the Wall 15

It’s already become a conversation piece. My team leader calls them “Grumpy Envelopes” and enjoys putting her tiny elf-like fists in the folds.

Fold 'em to the Wall 18

Rustic Pencil Holder and Homemade Pencils

Rustic Pencil Holder

I saw this about a year ago, and I remember thinking at the time that it was such a simple yet elegantly nifty project I would have to make it sometime.  What better time than the present?

Pencil-Holder 27

I wrangled a log out of the mildewed pile in our dilapidated excuse for a shed and got to work.  You can of course use any form of windfall or anything you find lying around.  I’d love to try this with driftwood, if I still had my beach handy.  As it was a pretty long chunk of wood, I figured I’d make three pencil holders, just to spread the love amongst my Christmas gift recipients.

Pencil-Holder 1

I also thought I might make them slightly angled, so that all the pencils or pens could be viewed from one side, instead of them all being on the same level. So I sawed them accordingly, in varying thicknesses.  Actually, the Pie did most of this because I took too long.  But we didn’t really try too hard to get things level or straight — the crooked adds to the charm, and I swear we did this on purpose.

Pencil-Holder 22

And then the bark, which had been sitting and drying out over our kitchen heater for two months, just peeled right off so easily.

Pencil-Holder 23

Pencil-Holder 24

I used a butter knife to get the thinner inner bark off.

Pencil-Holder 25

Now you drill your holes.  I used 3/8″ and 1/2″ drill bits, to accommodate skinny and fat pens and pencils. You know, like the fat ones you pick up from the bank or that you get in swag bags at conferences and stuff.

Pencil-Holder 30

You can space them out evenly or put them in randomly, whichever floats your boat.

Pencil-Holder 31

To make sure that all your holes are uniform in depth, use a bit of tape around your drill bit to mark how deep you want it to go.  When the line of the tape touches the wood, you’ve gone far enough.

Rustic Pencil Holder

In addition, if you are pursuing an angled approach, make sure that your drill is going in perpendicular to the surface upon which the wood is sitting, not perpendicular to the surface of the top of the disk.  Although I suppose you could do that, too, if you wanted your pencils to stick out at an angle.

Rustic Pencil Holder

Then I sanded, to smooth out the edges and to make the top nice and even.  You don’t want splinters in something you’re going to be touching all the time.

Rustic Pencil Holder

I stained one of them as well, again for kicks.

Pencil-Holder 32

Pencil-Holder 33

Pencil-Holder 34

To go with the pencil holders, I thought I would include some pencils I made myself.

Pencil-Holder 35

Pencil-Holder 36

I got the idea from here, but modified it so it was easier for me (because I found this actually quite difficult).  You need some 2mm pencil leads, the kind that go into architectural drafting pencils (also known as clutch pencils).  They tend to come in small plastic boxes of 10, and you can find them at art supply stores or on the internet.

Pencil-Holder 2

Then you need some thin paper.  I used a combination of newspaper flyers and origami paper for this, with the cheap newspaper on the inside and the nice origami pattern on the outside.  Cut the paper into squares that are the same length as the leads, which is usually about 5″.

Pencil-Holder 8

Take a paint brush and some glue and paint some onto the edge of one of the pieces of paper.

Pencil-Holder 9

Lay your lead onto the glued surface, just a little bit from the edge.  Fold that extra part over the lead and tuck it in.

Pencil-Holder 10

Now start rolling, carefully, putting even pressure on both ends of the lead.  You want the paper to be tight around the lead but you don’t want to put too much pressure on it that the lead breaks.  I definitely broke a few.  And go slowly, so you can make sure that the lead rolls straight in the paper.  Many of my pencils came out crooked and had to be trimmed later.

Pencil-Holder 11

When you reach the end of the paper, add some more glue and fasten the edge securely on your roll.  Repeat with more paper until you get to the thickness you like, with some nice patterned stuff on the outside.

Pencil-Holder 12

Put some glue on the outside, just to seal it all in.

Pencil-Holder 14

Allow your pencil to dry, then trim the pointy end of the pencil with a knife or a pencil sharpener, and you’re all set.

Pencil-Holder 21

Rustic Pencil Holder

Rustic Pencil Holder