Last time we ended with knitting up to the top of the thumb.Now we are going to start decreasing our stitches in order to taper over the fingers. First, count the number of stitches you have.In this case I had 34 stitches. You will of course have more if you are making larger mittens, or less if you are making smaller mittens. You will want to decrease your stitches at 5 different points in your row, as evenly spaced out as possible. Thirty-four is not evenly divisible by five, so I fudged it a bit. Here I knit two together at every 7th stitch, with the last going at the 6th.Now knit one row plain.In the next row, decrease again, knitting two together in the same places you did it last time. Remember that you now have four less stitches, so adjust your count accordingly. Keep going until you reach the top of your hand.So you have stitches here on 3 needles.We want all the stitches on 2 needles only now, divided evenly, so start sliding stitches from your middle needle onto the other two until it’s empty and stitches on both sides are equal.Like this:Now we start the grafting process. For this you will need a darning needle or blunt tapestry needle.I’m not sure I can explain this properly, so I’m not going to bother. But here is a pretty clear explanation. Essentially you use the needle as a knitting needle and alternately purl and knit your stitches off the needle, pulling off every second one.For my first try I didn’t do a very good job. I think I forgot to stick the needle in knitways and purlways, only doing it purlways, and so my edge is not as good as it could be.Now turn the mitten inside out and stick your needle through.Finish it off with a few hidden stitches and tie a knot.In our final lesson we will learn how to finish off the thumb. Stay tuned!